Moxa Technologies MGate MB3000 Modbus Uživatelský manuál stáhnout pdf (Strana 27)

MGate MB3000 User’s Manual Hardware: MB3480

5-4

Jumpers

To add a 120 Ω termination resistor, set switch 3 on the port’s assigned DIP switch to ON; set

switch 3 to OFF (the default setting) to disable the termination resistor.

To set the pull high/low resistors to 150 KΩ, set switches 1 and 2 on the port’s assigned DIP switch

to OFF. This is the default setting.

To set the pull high/low resistors to 1 KΩ, set switches 1 and 2 on the port’s assigned DIP switch to

ON.

Switch 4 on the port's assigned DIP switch is reserved.

ATTENTION

Do not use the 1 KΩ pull high/low setting on the MGate MB3000 when using the RS-232 interface.

Doing so will degrade the RS-232 signals and reduce the effective communication distance.

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 85 86

Žádné komentáře

Moxa Technologies MGate MB3000 Modbus Uživatelský manuál Strana 27