Moxa Technologies 332 Instalační příručka stáhnout pdf (Strana 15)

2-5

The next step is to attach the unit to the rail.

STEP 1: The two ends of the bracket

are named A and B. Hook the

A end over the top edge of

the rail.

STEP 2: Push the unit against the rail.

You should hear the B end

clicking into place over the

bottom edge of the rail.

To remove the unit from the rail, simply reverse Steps 1 and 2 above. Use your

fingers to pull down on the B end, which should release the bracket from the rail.

Network Connection

There are two ways to use the 10/100BaseT Ethernet jack located on the unit’s

rear panel.

1. For most applications, simply plug one end of your Ethernet cable into the

10/100BaseT jack, and the other end into the hub connected to your network.

In this case, use a standard straight-through Ethernet cable.

2. Use a crossover Ethernet cable when connecting the NPort Server Lite

directly to your computer’s Ethernet port, such as when configuring drivers

and software. A crossover Ethernet cable is included with the NPort Server

Lite.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 34 35

Žádné komentáře

Moxa Technologies 332 Instalační příručka Strana 15